The spoiler is supplied in basic white and without a cut-out for the cooling unit
Height regulation 60 - 90 cm
WURTH glue included
INSTALLATION INSTRUCTIONS:
1.Degrease the joint between the vehicle stem and the spoiler thoroughly with thinner.
2.Apply glue to the roof of the vehicle. possibly the edge of the spoiler (Before applying the glue, it is good to pre-heat the tube in warm water, which will cause greater plasticity of the adhesive)
3.Place the spoiler on the nose of the vehicle and tighten it with the fastening belt.)
4.Adjust the height of the spoiler accordingly to the height of the superstructure and tighten the locking bolts. (Check the tightening of the screws after some time)
5.Remove excess glue and seal the joint between the roof and the spoiler.
6.Remove the fastening strap after 24 hours.vw1002